Conceptual image of two slightly rotated hexagonal carbon lattices forming a larger pattern

A Small Stretch Changes the Resistance of Magic-Angle Graphene

Researchers at the University of Washington put two sheets of graphene together, rotated them by about a degree and pulled gently along one direction. The sample’s resistance shifted sharply as they adjusted the strain. A study published in Science on 12 November reports that the relative sensitivity was more than a hundred times that of conventional metals under some of the conditions they tested. The measurement gives physicists another way to study how electrons interact in magic-angle graphene. Ma and colleagues’ research paper.

Conceptual image of two slightly rotated hexagonal carbon lattices forming a larger pattern
AI-assisted illustration of overlapping carbon lattices. The angle and spacing are schematic.

What is magic-angle graphene?

Graphene is a sheet of carbon atoms arranged in a honeycomb lattice. Put two sheets together with a slight twist and their lattices line up at some points and drift apart at others. This creates a larger repeating pattern, called a moiré pattern. The electrons in the two layers move through that arrangement, and changing its geometry can change how easily they move.

Near a twist of 1.1 degrees, some of the electronic bands become unusually flat. That means electron energy changes relatively little across a range of momenta, making interactions between electrons especially important to the material’s behaviour. Earlier experiments found that under certain conditions such a sample can become superconducting. The new study asks how its electrical resistance responds to a separate change in the geometry. University of Washington research account and moiré demonstration.

How can a tiny stretch change resistance?

The team attached its sample to a device that changes length when a voltage is applied. This allowed it to stretch or compress the sample gradually along one direction and measure resistance as it went. Strain can arise accidentally during fabrication. Applying it deliberately allowed the researchers to track the response as they changed the strain instead of comparing two devices that may also differ in other ways.

They reported a large gauge factor, a measure that relates the fractional change in resistance to the applied strain. The comparison of more than a hundred times refers to that sensitivity. The response depended on temperature and on band filling, which here means how many electronic states are occupied. That dependence tells researchers where to look for the strongest collective effects. The authors’ open manuscript.

In selected filling ranges, the strain response grew markedly as the device cooled. That pattern gives researchers more to explain than a single large number would. A proposed microscopic account has to explain why the response grows at some fillings and temperatures, and why it changes as the electron population shifts.

Three steps in the experiment: twist two graphene layers near 1.1 degrees, strain the sample along one direction and measure the resistance
AI-assisted illustration of the experimental sequence. The lattice drawing is schematic. Source paper in Science.

What might be causing the large response?

One possibility the authors discuss is that the electrons are close to adopting a preferred direction. Pulling along one axis could then have an especially large effect. The team also considers fluctuations in internal electronic properties. The resistance measurements give these explanations something to account for, but the paper leaves the microscopic cause open.

The result gives laboratories a way to vary the lattice in the same sample while changing its temperature or electronic filling. One follow-up would be to see whether different atomically thin materials respond in the same way. Another would be to compare directions of applied strain. The broader question is which effects come from the lattice geometry and which depend on the particular electrons in that material. Our coverage of the quantum gas microscope describes a separate experiment in which tuning the conditions also helps test how particles interact. Read about the quantum gas microscope.

Leave A Comment